FLOOR CLEANING
CONNECTION OF THE BATTERIES TO THE MACHINE
Plug in the batteries connector (1) to the machine connector (2), placed
in the rear part of the machine.
RECOVERY TANK
Verify that the squeegee hose coupling (1) is correctly inserted into its
seat and that the exhaust hose plug (2) is well closed.
The recovery tank is provided with a cover (3) that blocks itself thanks
to the vacuum created by the suction motor during its use.
DETERGENT SOLUTION TANK
The solution tank is provided with an inspection opening. This permits
to clean the exit point of the detergent solution.
Be sure that the cap is well tightened after the cleaning.
The capacity of the detergent solution tank is indicated in the technical
data.
Open the screw plug placed in the rear right part of the machine and
fill the detergent solution tank with clean water at a maximum
temperature of 50°C. Add the liquid detergent in the percentage and
conditions foreseen by the manufacturer. To avoid excessive foam
presence, which could cause problems to the suction motor, use the
minimum percentage of detergent recommended.
Always on the left side of the machine there is placed a level hose that
permits to see easily the solution quantity inside the tank both during
the filling of the solution and during the working.
Screw down the plug of the solution tank.
Use always low foam detergent. To avoid foam presence, before starting
working operation, introduce into the recovery tank a minimum
quantity of anti-foam product.
Never use pure acid
.
3S SYSTEM “SOLUTION SAVING SYSTEM” (OPTIONAL)
The system is composed
by a hydraulic circuit
parallel to the
traditional one which
can be enabled or
disabled directly from
the instrument board
keeping pressed for
about 3 seconds the
push button (1).
When the system is on,
the 3S symbol appears
on the display as shown
in the picture.
Once activated you can proceed with the cleaning.
12