Contents
Connection .....................................
4-5
Setup for Testing ............................
6-7
Testing the Dispensers ....................
8-9
Making Timed Deposits of Medium to Thick Fluids
Changing Deposit Size and Drawing Stripes
Programmable Timer .........................
9
How to Use the Vacuum Control ...
10-11
Making Timed Deposits of Watery-thin Fluids
Component Dispensing System......
12-13
Loading the Barrel Reservoirs........
14-15
Schematic & Parts............................
16
Troubleshooting ..............................
17
Suggestions & Reminders.................
18
Reordering Components ..................
19
Two Year Limited Warranty..............
20
Meets applicable CE requirements.
Initial Steps
One
: Unpack and use the checklist enclosed with the Dispenser Kit to identify all items. If there
is any discrepancy, please call us immediately.
Two
: Power and compressed air should be available where the dispenser is to be set up. Air
pressure should be between 80 and 100 psi (5.5 and 6.9 bar). If you are not using an ADL five
micron filter regulator #TSD800-6, be certain your factory air is properly filtered and dry and a
regulated, constant air pressure is supplied to the dispenser.
Warning:
Bottled nitrogen can be used.
If high pressure bottled air or nitrogen is used, a high
pressure regulator must be installed on the bottle and set at 100 psi maximum. The TSD800-6
filter regulator is not recommended.
Three
: ACTIVATE your Two Year Limited Warranty. Please fill in and return the Warranty card.
Or if you prefer, call the appropriate number listed below, provide the serial number of your dis-
penser and respond to a few short questions.
In the UK, call free 0800-094-0958
.
In the US, call 866.735.4456.
