If you choose
not
to use the piston, please follow these in-
structions carefully:
1. While holding the barrel upright in one hand, twist on an or-
ange, black or white tip cap. Using a small funnel, fill about 2/3
full with your fluid.
2. Open the white safety clip and attach the barrel to the 10cc
adapter.
3. Close the white safety clip as tight as possible.
4. Increase vacuum by gently turning vacuum control knob
counter clockwise.
5. Then, without tipping the barrel upside down, remove the tip
cap and attach the 25 gauge (red) #TE725050PK tip.
6. Open the safety clip. Your material may begin to bubble. Re-
duce vacuum by turning vacuum control knob clockwise.
7. If a drop begins to form at the end of the tip, slowly turn the
vacuum control knob counter clockwise to stop the drop from
growing. Wipe the tip and adjust vacuum as necessary.
Now the fluid is in proper balance. It does not bubble or drip.
Repeat tests as before, keeping the air pressure low and ad-
Some things to remember
If you do not use the piston
when dispensing thin fluids:
Do not tip the barrel upside down
or lay flat. This will cause the
liquid to run into the dispenser.
When changing tips
or attaching a tip cap,
snap the safety clip
completely closed to
prevent any dripping
or bubbling.
Use an ADL filter trap
(#1400-FLT). This
filter trap will impede
the flow should the
low viscosity liquid be
sucked back towards
the dispenser.
IMPORTANT
Regardless of the fluid viscosity, using the correct piston will give you improved results. White PE piston for most
fluids, blue Easy Flow piston for watery-thin fluids and red flat wall piston for thick, stringy fluids. See pages 12 -
13 for a complete description of how our pistons work and the benefits they can bring to your applications.
In the UK, call +44 (0) 1908 686660
.
In the US, call 866.735.4456
