Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
DALI / Serial - Converter
Document code: MN67831_ENG Revision 1.100 Pagina 42 di 56
Setting new Max value
This command is used to program the new maximum value of brightness in the DALI devices.
REQUEST
S_MAX_
id
_
val
(ASCII format)
Where:
‘id’ = ID of the DALI node (0 ÷ 63) or group (64 ÷ 79) or broadcast (80).
‘val’ = value of new max value to set (0 ÷ FF, Hex representation)
Note:
Just ‘id’ and ‘val’ are variables, the rest of the ASCII string is fixed.
Note:
In order to address the Serial command to a specific converter in the serial line, it is necessary to add at the start of the commands
the chars “nnn.” where ‘nnn’ is the ID Board set in section “Set Communication” of SW67831. The response will contain the additional chars
too.
