12
Electrical Shock Hazard
Plug into a grounding wall outlet.
Never remove the ground prong.
Use separate power supply or receptacle.
Never use an adapter.
Never use an extension cord.
Failure to follow these instructions can result in death, fire, or
electrical shock.
When installing the ice maker under a counter, follow the recommended spacing dimensions shown
above. Place electrical and drain fixtures in the recommended locations as shown.
Choose a well-ventilated area with temperatures above 10
℃
and below 32
℃
. This unit MUST be
installed in an area protected from some elements, such as wind, rain, water spray or drips.
The ice maker requires a continuous main water supply with pressure 1-8 Bar as required in above
specification table. The temperature of the water feeding into the ice maker should be between 5
℃
and 25
℃
for proper operation.
ELECTRICAL REQUIREMENT & CONNECTIONS
WARNING: THIS UNIT MUST BE EARTHED.
Before you move your ice maker into its final location, it is important to make sure you have the proper
electrical connection.
It is recommended that a separate circuit, serving only your ice maker, be provided. Use receptacles
that cannot be turned off by a switch or pull chain. If the supply cord or plug to be replaced, it should be
done by a qualified service engineer.
This appliance requires a standard 220-240Volt, 50Hz electrical outlet with good grounding means.
Recommended grounding method
For your personal safety, this appliance must be properly grounded. This appliance is equipped with a
power supply cord having a grounding plug. To minimize possible shock hazard, the cord must be
plugged into a mating grounding-type wall receptacle, grounded in accordance with the National
Electrical Code and local codes and ordinances. If a mating wall receptacle is not available, it is the
personal responsibility of the customer to have a properly grounding wall receptacle installed by a
qualified electrician.
CLEANING
CLEANING
YOUR
YOUR
ICE
ICE
MAKER
MAKER
BEFROE
BEFROE
FIRST
FIRST
USING
USING
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1. Open the ice taking door.
2. Clean with diluted detergent, warm water and a soft cloth.
3.
Repeatedly clean the water contacting inner parts, use the water or the wet clothe to scrub the
