Page 9
Manual SVL 4G Weblogger
Adesys B.V. | Wateringen
3.6.4 Factory reset
By performing a factory reset all settings will be lost and a reset to the default settings will be prompted.
4
Notification procedure
The notification procedure starts in the event of a status change or error. If set up, the SVL will first
establish a data connection and send data, and then send the associated notification message to the first
contact on the call list that has been set up.
4.1 Notification message
An SMS or e-mail alarm message is structured as follows:
Device name | input name | status
.
• Device name
: contains a text chosen by the user. This can be set up in the system menu.
• Input name
: contains a text chosen by the user, which is coupled to the input channel. This can be set
up in the I/O menu for the relevant input.
System errors such as the Ethernet error and the ‘no numbers coupled’ error have a fixed text (in English)
that cannot be changed. For example, powerfailure is used for a mains power failure.
•
Status:
shows whether an input channel is Active or Idle. Active and recovery texts can be set up in the
system menu.
This is used if an E-mail address is entered in the call list. In the event of a notification, the dialer first
sends a message to Checkmyproces via httpost, whereupon Checkmyproces converts the notification
into an E-mail message and sends this to the E-mail address that has been entered. The structure of the
message is the same as the SMS.
4.2 Notification of status changes
After input channel 1 has been activated, the following can be observed:
•
The green LED (
on/busy
) flashes 1x to indicate that input channel 1 is active;
•
After a few seconds, the green LED (
on/busy
) flashes faster to indicate that the SMS message is being
sent;
•
The green LED (
on/busy
) again flashes 1x. The SMS message has been sent;
•
The notification message appears on the mobile phone to which the SMS message has been sent; this
message can be structured as follows:
LOCATION PUMP FAULT Active;
•
The green LED (on/busy) continues to show the status of the input until this ceases to be active;
•
If the input returns to idle mode and a recovery report has been set up, the notification message will be
structured as follows:
LOCATION PUMP FAULT Idle.
4.3 Notification of mains power failure
The SVL is equipped with a supercap. This gives the dialer the option of sending a few messages in the
event of a power failure. The associated notification message is sent to the first number in the call list
linked to the mains power failure. After the power fails, the following can be observed:
•
The red LED (
error
) flashes 5x to indicate that the supply voltage has been lost;
•
After a few seconds, the green LED (
on/busy
) flashes faster to indicate that the SMS message is being
sent;
•
The green LED (
on/busy
) remains on. The SMS message has been sent;
•
The notification appears on the mobile phone to which the SMS message has been sent; this message
can be structured as follows:
LOCATION powerfailure Active
;
•
The red LED (
error
) continues to show the status of the mains power failure until this has been
recovered.
A mains power failure message always takes priority over an ongoing notification of a status change. After
notification of the mains power failure, any interrupted notification can be restarted. Notification of status
changes that have not yet been notified then continues. This priority arrangement applies for both
Active
and
Idle
.
Figure 2 Notification prodecure