Page 5
Manual SVL 4G Weblogger
Adesys B.V. | Wateringen
2 Connection
To connect the SVL correctly, we recommend using exclusively Camden CTB922HE/# type connectors.
Measurements may be affected if other connectors are used.
2.1 Positioning
Position the SVL where it is not affected by direct sunlight or other heat sources. Choose the place of
installation such that moisture cannot penetrate the device. The SVL can be mounted onto the TS35 rail
without screws. The permitted ambient temperature range for the electronics is -20°C to +55°C.
The transmission power of the SVL’s internal GSM/4G module is higher than that of a standard mobile
phone. Under certain conditions this may affect the functioning of surrounding electronic equipment. The
effects depend upon the distance between the antenna and surrounding equipment.
2.2 Affixing and removal: DIN rail
The SVL should be affixed to a DIN rail before connection.
•
Put the SVL onto the DIN rail at an angle [1]. It is important that the SVL’s DIN rail clip is positioned on
the top of the DIN rail.
•
Tilt the SVL to clip it into place [2]. Then check whether it is securely seated.
The SVL is removed from a DIN rail as follows.
•
Place a screwdriver on the underside of the DIN rail clip [3]. Use this as a lever; after approx. 3 mm the
SVL can be tilted to release it from the DIN rail.
2.3 SIM card
If the SIM card has a PIN code, this should be entered in the setup tool SV-prog. The required SIM card is
installed as follows:
•
Switch the SVL off by disconnecting the supply voltage, then press and hold the reset key for 8 seconds
to switch off the dialer;
•
The SIM card holder is made accessible by pressing the button next to it using a sharp object. The
holder is then pushed outwards;
• Place the SIM card in the holder and slide this back into the SVL;
• Reconnect the supply voltage to switch the SVL on.
The SVL should be completely switched off before the SIM card is installed. Fitting or removing the SIM
card with the SVL switched on may damage the SIM card.