ENGLISH
–
Rolling screen installation and operation manual
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Doc: MULTIFORMAT Installation Manual rev2 | 22.08.2018
Please verify that you are working with the latest revision of this document before specifying your screen.
Page 15
PROGRAMMING END STOPS FABRIC and MASK (procedures already carried out in factory, SHOULD NOT be performed by unauthorised personnel)
Each programming procedure consists of several steps; at the end of each step, the operator has 60 seconds to start the next step; this system is devised to prevent the risk of performing operations other
than those desired. Therefore, if the motor does not perform the operation exactly as indicated in the instructions, wait 60 seconds, then exit programming, or cancel the procedure as indicated at specific
point, and start the procedure all over again.
END STOP MASK MOVEMENT (SHOULD NOT be performed by unauthorised personnel)
The motor’s settings follow an overwriting logic: therefore, once the e
nd stop positions have been memorised they cannot be cancelled, but only overwritten by following the above-mentioned procedure from
the start.
TO CANCEL THE PROGRAMMING IN COURSE
In order to cancel the procedure in course, simultaneously press
and
at any time, until the motor has executed 6 movements.
