Work Light
The white LED work light will be lit after pulling the
switch trigger for illumination of the work area under
unfavorable lighting conditions. (Fig. 10)
Continuous Use
If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for
15minutes before proceeding with a fresh battery.
Setting the Fastening Torque
CAUTION:
Choose proper gear based on different workplaces.
The fastening torque can be adjusted in 3 steps.
According to the requirement of different workplaces, Press the button on the panel to set the torque
among step L, H and Smart-loosen. (Fig. 11)
Smart-loosen Step: Under this special smart-loosen step, to loosen the screw, simply set the
reversing switch lever to counterclockwise position.Once the screw is loosened, the tool will stop
immediately, even if the switch trigger is not released. This gear can be uesd to loosen but not
completely remove the screw. When set the reversing switch lever to clockwise position, the function
is the same as H step.
L Step: Press the switch trigger, and the tool runs continuously at a low speed. The maximum torque
is 240 N·m.
H Step: Press the switch trigger, and the tool runs continuously at a high speed. The maximum
torque is 300 N·m.
MAINTENANCE AND INSPECTION
Inspecting
When the tool is distributed or withdrew, the custodial staff must give it a daily inspection; before
use, users must give it a daily inspection; the companies using the tool must have professionals to
inspect the tool regularly; Inspection cycle should be shortened in the area of humid climate and
changeable temperature or under poor using conditions; Inspect in time before rainy season.
The tool that is inspected to be qualified should be marked with a sticker on which there are words
“identifier, name or identification of the inspecting company, name or identification of the inspector
and effective date.
The tool must be maintained by maintenance companies recognized by original manufacturer. The
end-users and maintenance departments are not allowed to change original parameter of the tool, or
adopt alternate materials whose performance is lower than original ones or spare parts that don not
correspond to the specifications.
Cleaning Ventilation Slots
For safe and proper working, always keep the power tool and its ventilation slots clean. Use a soft,
clean and dry brush to clean the ventilation slots regularly or when they’re clogged.
Inspecting the Mounting Screws
Regularly inspect all mounting screws and ensure that they are properly tightened. Should any of the
screws be loose, retighten them immediately. Failure to do so could result in serious hazard.
Cleaning
Only use soft and dry cloth to wipe the body of the tool. Do not clean the tool with wet cloth, thinner,
gasoline or other volatile solvents.
※
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment
should be performed by authorized service centers, always using original replacement parts.
Summary of Contents for MAC AFRIC SDRILC-007
Page 1: ......
