Rapid Eye Remote Video Unit Installation and Setup Guide
10
3.0 Installing the Remote Video Unit
☞
Note: Only terminate the video signal once, regardless of the
number of CCTV devices that are connected. Failure to do so
will cause poor image quality.
To set the DIP switches, do one of the following:
•
Set the video signal's DIP switch to ON (top of button pushed in) if the
Remote Video Unit is the last (or only) CCTV device in the series and
no other devices are terminating the signal.
•
Set the DIP switch to OFF (bottom of button pushed in) if another
CCTV device is already terminating the signal (usually the last device in
the series). This step ensures that the Remote Video Unit's input is in
high-impedance (Hi-Z). Refer to related equipment documentation to
find out how to terminate the signal at the specific device.
VID E O IN 1-8
1 2 3 4 5 6 7 8
O F F
P u s h to p in
to se t O N
Figure 3: Example of terminating a 4-camera (video 1-4) signal
