STAN07-210324-Rev005-UM-en
24
Settings for serial interfaces [dAtA]
The configuration of the serial data output can be set individually for the serial interface 1 and 2.
To set the configuration parameters, hold the
key for more than one second until the display shows
[PLUPrO]. Then repeatedly press the ► key until the display shows [dAtA].
The following diagram shows the procedure:
Settings for serial interface 1 [SPOrt1]
In this menu item, the type of the output device and the baud rate for serial port 1 can be set.
To make changes, first press the
key when the display reads [dAtA] and confirm again with the
key when [SPOrt1] appears in the display.
By means of the ▲ and ▼ keys, select the desired setting and confirm your choice with
to change
to the next menu item or press the
key to return to the previous menu item.
The following diagram shows the procedure:
Selection of the output device to serial port 1 [ForM]
Press the
key when [SPOrt1] appears in the display. [ForM appears in the display].
To select the output device, you have four options available:
n
Disabled. No device is connected.
C1
Continuous 1 (secondary displays).
C2
Continuous 2 (PC).
Pr
Printer.
The data output formats for the settings C1 and C2 are further described below.
Selection of the baud rate for serial port 1 [br]
Press the
key twice when [SPOrt1] appears in the display. [br] appears in the display.
Summary of Contents for STAN07
Page 35: ...STAN07 210324 Rev005 UM en 34...
