Addvalue Innovation wideye SABRE RANGER 5000, Quick Start Manual

Page: 8 / 32

SABRE™ RANGER 5000 Quick Start Guide
© 2020 Addvalue Innovation Pte Ltd. All rights reserved.
6
Ethernet Connection
• Use a CAT5 cable with the RJ45 plug for the Ethernet cable. Thread the Ethernet cable
through the conduit-fitting/Cable gland hole carefully.
• Insert the RJ45 Plug into the Ethernet Port 1 (as indicated below in red rectangle).
Power Supply input
• Connect a 12VDC or a 24VDC power supply which can source at least 30W - to the
Power connector, CON501. This Power supply input supports voltages from 10.8 to
32Volts.
• Use two AWG16 wires for power connection if the cable length is not more than 10m.
Otherwise, use AWG14 wires for a cable that can be lengthened up to 100m.
• Insert the red wire into the terminal block with (+) marking, the black wire into the
terminal block with (-) marking. Press and hold the orange tab on the terminal block
while inserting the wire into the hole.
NOTE : The sample wires below are used for reference. You may use different colour
wires that met the electrical specifications.
Figure 8