Addictive audio 100.1D, Installation Manual & Owner'S Manual

Page: 28 / 32

28
r to the center or flat
26. se a v . Turn the volume
st quality head
lume.
27. ise) to match the voltage output of the head
til the speakers reach the maximum undistorted output. Keep an
ye on
all and insufficient wire to connect the alternator’s positive
e
25. Set the head unit’s tone controls, balance, and fade
position. Be sure to turn off any loudness or other signal processors.
U ery clear original recording not mp3 or burned cd
of the head unit to its maximum undistorted volume. On mo
units this is around 7/8 of the maximum vo
Slowly turn up the gain (clockw
unit or un
e the clipping LED!
28. Adjust the low pass, high pass, subsonic filters and phase to desired
settings.
29. Play a few different selections of music to check for overall system
balance.
30. ENJOY!
NOTE:
Many vehicles have sm
connection to the battery and to ground the battery to the vehicle chassis. To prevent
voltage drops, these wires should be upgraded to 4-0 AWG when installing one or mor
Addictive Audio amplifiers.