Addictive audio 100.1D, Installation Manual & Owner'S Manual

Page: 12 / 32

12
and the Strap Mode switch is set
MAS
in Control (Bass knob) turn the dial all the
7. Attach the recommended fuse
(refer to fuse chart on pg.4)
to the fuse holder by
10. Set the head unit’s tone controls, balance, and fader to the center or flat
n off any loudness or other signal processors.
ad
e speakers reach the maximum undistorted output. Keep an
and adjust the BOOST
ve i it effectively and
or overall system
5. Make sure Bass EQ switch is set to OFF
to .
6. If using the supplied Remote Ga
way up to the max. (full clockwise)
the main battery.
8. Re-attach the negative battery post from step 1.
9. Turn the head unit on and start at a low volume. Check amplifier to make
sure all wires are correct and no protection lights are on.
position. Be sure to tur
11. Use a very clear original recording not mp3 or burned cd. Turn the volume
of the head unit to its maximum undistorted volume. On most quality he
units this is around 7/8 of the maximum volume.
12. Slowly turn up the gain (clockwise) to match the voltage output of the head
unit or until th
eye on the clipping LED!
13. Re-adjust the low pass filter and phase if needed.
14. Turn the Bass EQ “ON” if desired. Now set the center point frequency
(refer to EASY CLICK chart on pg. 13 for exact tuning)
nstalled the Bass Knob, now you can use
f music to check f
accordingly. Keep an eye on the clipping LED!
15. If you ha
safely.
16. Play a few different selections o
balance.
17. ENJOY!