Addi-Data APCI-1710, Technical Description

Page: 28 / 84

APCI-1710 Software
27
Shows the selected DMA channel or “Not available” if the board do not use
one.
More information:
Further information is shown by the dialog box, for example the sign chain
for the identifier (e.g. PCI1500-50) or the installed COM interfaces. If the
board is programmed with ADDIDRIVER this will be shown.
Text boxes:
In this table you can find 6 boxes for text input with which you can modify
the board’s parameter.
Base address name:
If the board is operated by various base addresses (one for the first interface,
one for the second interface etc.) you can decide which base address is to be
changed.
Base address:
In this box you can select your PC-board’s base address. All vacant base
addresses are listed. A base address that is already used is not displayed in
this entry.
Interrupt name:
Selection of the interrupt number that shall be used by the board.
DMA name (for ISA boards only):
When the board supports 2 DMA channels, you can select which DMA
channel you want to change.
DMA channel:
Selection of the used DMA channel.
Buttons:
Edit:
Selection of the highlighted board with the different parameters set in the
text boxes.
Click on Edit to confirm the entries or click twice on the selected board.
Sets the parameterized board configuration. The configuration should be set
before you save it.
Insert:
If you want to insert a new board click on “Insert. Then the following box is
displayed: