21
NOTE:
To stop the dryer at any time, open the main door. To continue the cycle, close the main door,
the Phase 6 OPL microprocessor controller (computer) prompts the operator “PRESS
START” then press the “ENTER/START”
Key. The dryer will continue from where it left
off, or ... the dryer may also be stopped by pressing the “CLEAR/STOP”
Key. However,
the cycle that was in progress
will be cancelled
, and the light emitting diode (L.E.D.) display
will return to the “REAdY” (no cycle in progress) Mode.
8) Once the programmed drying time has expired, the Phase 6 OPL microprocessor controller (computer)
will proceed into the Cool Down Cycle (Mode) and the Cycle In Progress portion of the L.E.D.
display will read COOL___MIN REMAIN and dRUM TEMP___F. (FLASH [PL5]
must be
active for the “dRUM TEMP” to display. If “N FLASH” is active then press “ENTER/
START”
Key to display “dRUM TEMP.”)
9) Once the Cool Down Cycle is completed, the dryer will shut off, the tone (buzzer) will sound (i.e.,
7-seconds), and the L.E.D. display will read “dONE.” The L.E.D. display will continue to read
“dONE” until the main door is opened.
10) If the Anti-Wrinkle Program is active (on), once the drying cycle and cooling cycles are completed
and the L.E.D. display reads “dONE” the Phase 6 OPL microprocessor controller (computer) will
proceed into the Anti-Wrinkle Program, L.E.D. displays “START GUARd.” If the main door is not
open within the Anti-Wrinkle Delay Time (i.e., 90-seconds), the basket (tumbler) will rotate (without
heat) for the programmed Anti-Wrinkle On Time (i.e., 20-seconds). The Phase 6 OPL microprocessor
controller (computer) will repeat this process until the programmed Maximum Anti-Wrinkle On
Time has expired (i.e., 10 minutes). The L.E.D. display will read “dONE” until the main door is
opened.
B. OPERATING NOTES
1. If the main door is opened while a cycle is in progress the L.E.D. display will read “MAIN dOOR.” The
L.E.D. display will continue to read “MAIN dOOR” until the main door is closed. Once the main door is
closed, the L.E.D. display will read “PRESS START.” The “ENTER/START”
Key
must now be
pressed to resume the drying cycle and cooling cycle.
2. If the system parameters [PL 5] is not programmed for “FLASH” the “dRUM TEMP” L.E.D. is displayed
by pressing the “ENTER/START”
Key.
3. Preprogrammed Cycle “F” has been programmed by the factory as a “Touch-Up Cycle” (unless otherwise
specified at the time of ordering the dryer). This Touch-Up Cycle is programmed to operate in the timed
(Manual) Drying Cycle for 10 minutes of drying time at 170º F and a 2 minute cool down.
4. A cycle in progress can be stopped and
cancelled
at any time by pressing the “CLEAR/STOP”
Key.
The L.E.D. display will return to the “REAdY” Mode (no cycle in progress).
5. When using the manual selection cycle, if an error is made making an entry, press the “CLEAR/STOP”
Key
ONCE
, and the entry
will be cancelled
. Re-enter the selection.