ADC 410F, User Manual

Page: 32 / 106

Using the RS-232 management Port for Set Up
24 Megabit Modem 410F and 420F User Manual
U
SING THE
RS-232
MANAGEMENT
P
ORT FOR
S
ET
U
P
You can configure some parameter for the Megabit Modem 410F and 420F modems through
the RS-232 port that is connected to a PC. You can use the Megabit Modem Setup Menu to do
the following:
• manually change the LAN and WAN IP address and network mask
• enable Dynamic Host Configuration Protocol (DHCP)
• configure modem parameters (these are a subset of the parameters that can be configured
using the Megabit Modem 410F and 420F Web pages)
Pairgain Megabit Modem 410F Setup Menu
========================================================
BSP version: 2.2
SW version: 2.8
========================================================
(1)Enter LAN IP address: 192.168.0.1
(2)Enter LAN IP network mask: 255.255.255.0
(3)Toggle Bridging: Enabled
(4)Toggle Routing: Disabled
(5)Toggle LAN DHCP: Disabled
(6)Toggle Spanning Tree: Enabled
(7)Enter WAN IP address:
(8)Enter WAN IP network mask:
(9)Toggle LAN RIP: Enabled
(10)Toggle WAN RIP: Enabled
(11)Enter default gateway IP address: 0.0.0.0
(12)Enter IP Admin address: 0.0.0.0
(13)Set Factory Defaults
(14)Reset modem
>