ADB Safegate L-854, User Manual

Page: 26 / 48

Note
Use four 1/4 x 1 in.- (6.35 x 25.4 mm-) long lag screws with 1/4 in. flat washers (or other suitable fasteners) for
mounting, or as appropriate for the surface to which the radio unit is being mounted.
Figure 6: Mounting Dimensions
4. Route power to the unit.
Note
This must meet the National Electric Code (NEC) and/or any local codes.
5. See Table 4 .
Connect 120V AC (or 240V AC) to the terminal block as follows:
a) White wire to terminal #12 (neutral)
b) Black wire to terminal #13 (load)
c) Green wire to terminal #14 (ground)
Or connect 12V DC (or 48V DC) to the terminal block as follows:
d) Black wire to terminal #12 (negative)
e) Red wire to terminal #13 (positive)
6. Connect the Decode Disable signal to terminal 1 and terminal 3, if used.
The Radio Control Equipment will operate in both individual and cumulative control, see Table 6 and Table 7 .
7. Place the voltage to be switched for the Channel A relays on Terminal 4, and the voltage to be switched for the Channel B
relays on Terminal 11.
L-854 Radio Control Equipment
Installation
20
Copyright
©
ADB Safegate, All Rights Reserved