ADB Safegate L-854, User Manual

Page: 25 / 48

5.0 Installation
WARNING
Read installation instructions in their entirety before starting installation.
• • Become familiar with the general safety instructions in this section of the manual before installing,
operating, maintaining or repairing this equipment.
• • Read and carefully follow the instructions throughout this manual for performing specific tasks and
working with specific equipment.
• • Make this manual available to personnel installing, operating, maintaining or repairing this
equipment.
• • Follow all applicable safety procedures required by your company, industry standards and
government or other regulatory agencies.
• • Install all electrical connections to local code.
• • Use only electrical wire of sufficient gauge and insulation to handle the rated current demand. All
wiring must meet local codes.
• • Route electrical wiring along a protected path. Make sure they will not be damaged by moving
equipment.
• • Protect components from damage, wear, and harsh environment conditions.
• • Allow ample room for maintenance, panel accessibility, and cover removal.
• • Protect equipment with safety devices as specified by applicable safety regulations.
• • If safety devices must be removed for installation, install them immediately after the work is
completed and check them for proper functioning prior to returning power to the circuit.
Failure to follow these warnings may result in serious injury or equipment damage.
This section provides instructions for the installation of the L-854 Radio Control Equipment. Refer to the project plans and
specifications for the specific installation instructions.
5.1 Unpacking
The equipment must be handled carefully to prevent component damage. Unpack the carton upon receipt and check the
contents and their condition. Note any exterior damage to the carton that might lead to detection of equipment damage.
If you find any damage to equipment, file a claim form with the carrier immediately. Inspection of equipment by the carrier
may be necessary.
5.2 Installing L-854 Radio Control Equipment
To install the standard L-854 Radio Control Equipment, perform the following procedure:
1. Determine the best location for the Radio Control Equipment.
Note
Radio Control Equipment location should be within 50 feet (15.24 m) of the antenna and secured to a wall. The
standard cabinet (NEMA 4) is rated for an indoor or outdoor environment. Consideration should be given to
locating it out of a traffic area to reduce or minimize its exposure to unauthorized personnel. Consideration should
also be given to the routing of the antenna lead-in cable, if used. Route it away from heavy concentrations of
electrical wires to reduce interference.
2. Use extreme care when drilling the entrance holes for the power, control and, antenna wiring.
Avoid drilling into the enclosure in such a way as to allow metal filings can fall onto the electronics or, allowing the drill bit
to contact the equipment inside.
3. See Figure 6 .
Install the radio unit using the four mounting holes.
96A0390, Rev. K, 2019/02/01 19
Copyright
©
ADB Safegate, All Rights Reserved