Adaptive JUNIOR, User Manual

Page: 27 / 28

Adaptive® JUNIOR – Technical and HMI User Guide
REV 1.04 27
46=1, 54=2, 62=3 Integer See Table 10 Fan (x) alarm enables
63 Integer Fan PSU supply voltage setting
0 = Off – use voltage in supply
1 = 5V
2 = 12V
3 = 24V
64 Integer See Table 11 Current fan alarm status
65=A, 66=B, 67=C, 68=D Floating point Read only Temperature sensor (x) value
69=1, 72=2, 75=3 Floating point Read only Fan (x) current value
70=1, 73=2, 76=3 Floating point Read only Fan (x) voltage value
71=1, 74=2, 77=3 Integer Read only Fan (x) speed
78 Floating point Read only Bridge voltage (TEC) value
79 Floating point Read only Current monitoring voltage
80 Floating point Read only Bridge current (TEC) value
82 Integer Read only Current PWM output value
83 Floating point Read only Supply voltage value
84 Floating point Read only On board potentiometer reading
90=A, 92=B, 94=C, 96=D Floating point Calibration gain for sensor (x)
91=A, 93=B, 95=C, 97=D Floating point Calibration offset for sensor (x)
Table 7 Status bit details
Bit = 1 indicates condition is active
Table 8 Bit arrangement for alarm enable, relay and shutdown registers
Sensor Sensor D Sensor C Sensor B Sensor A
Alarm type High Low High Low High Low High Low
Bit number 7
6 5 4 3 2 1 0
Bit = 0 disabled, Bit = 1 enabled
Table 9 Temperature alarm status bits
Sensor Sensor D Sensor C Sensor B Sensor A
Alarm type High Low High Low High Low High Low
Bit number 7
6 5 4 3 2 1 0
Bit = 1 indicates alarm condition is active
Bit number Status (1 = alarm active)
0 Shutdown
1 Relay active
6 Heat or cool
11 Auto tune complete
12 Auto tune failed
13 Internal fault
14 Communications fault
15 Communications fault