Adam ADI0009, Use & Care Manual

Page: 4 / 16

0 4
SECTION 01
PLEASE DO NOT OBSTRUCT THE AIR VENTS OF THE FIRE’S HEATER UNIT
This appliance has a ‘self resetting’ safety cut out system. To prevent overheating,
ensure the air inlets and outlets are not obstructed. If the safety cut-out operates,
switch off the fire and allow to fully cool down. Remove any obstruction
before re-use.
IMPORTANT ELECTRICAL SAFETY
The plug must always be accessible, after installation, in order to disconnect the fire
from the electrical supply for maintenance cleaning or isolation in an emergency.
If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
This fire must be earthed. The supply cord must be safely routed from the fire to an
electrical socket.
Any new wiring required, must be In accordance with local and national codes and
other applicable regulations in order to reduce the risk of fire, electric shock, or other
injuries. Always use a certified electrician should new circuits or outlets be required.
Avoid the use of an extension cord which may overheat and cause risk of fire.
If an extension cord is necessary, it must be rated above the maximum rated power
of the appliance. Care must be taken to arrange the cord so that it cannot be pulled
or be tripped over.
IMPORTANT!
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have had supervision or instruction concerning use of
the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• This heater is not equipped with a device to control the room temperature. Do not
use this fire in small rooms when they are occupied by persons not capable of
leaving the room on their own unless constant supervision is provided.
• This heater is hot when in use. To avoid burns, do not touch hot surfaces such as
surfaces around the grille in front of the heater. Never let bare skin touch hot
surfaces.
• Do not spray liquids directly onto any surface of the unit.
Warning: In order to avoid overheating, DO NOT COVER THE HEATER UNIT
Note: When the fire is turned on for the first time or when it has not been
used for some time, it may release a slight, harmless odour. This odour is a normal
occurrence caused by the initial heating of the internal heating elements and
will disappear with use.