Adagio Water Features Inspiration Falls Assembly & Mounting Instructions
5 of 7
3)
You will need to lift the stone high enough to clear the top of the Water Tray. Bring the bottom of the
stone inside the Water Tray and lift it high enough to rest it on the Wall Bracket. You may slide the
stone from side to side until it is in the middle of the Water Tray. Be careful not to pull the stone away
from the wall at the bottom as this can damage the mounting bracket.
6. Installing the Water Distribution and Pump
1)
From the top of the stone, feed the hose through the notched middle area of the brackets.
2)
Take the Water Distribution Unit (WDU) and attach the top of the hose to its copper nozzle using the
hose clamp to ensure a tight fit.
Warning: Watch for sharp edges on the copper, they can cut
easily.
3)
Place the WDU on the top of the stone with the copper nozzle in the back and pointing down. Make
certain it is level.
4)
The tabs on the back of the WDU can be used to adjust the fit of the WDU on the stone. Because the
stones vary in thickness the tabs may need to be bent dramatically to ensure a tight fit across the
stone. It may take some maneuvering, but it is worth the time and effort now to get a good fit because
it will only become more difficult later in the installation.
Note:
For stones that are thinner than normal you may apply the supplied ¼” thick foam tape to the inside
of the back tabs on the WDU. Do not put any type of spacers on the front lip of the WDU. The functionality
of the water feature depends on a close fit between the front lip of the WDU and the front of the stone.
5)
After installing the WDU, vigorously rub the supplied Scotch Brite pad on the front copper piece of the
WDU that over hangs the stone by a couple inches. This is where the water will flow and rubbing the
pad over the entire section will help with overall water coverage.
Note:
The Baffle fits inside the WDU and should already be there. The Baffle has a set of wings on both
sides. The smaller wings should be on the top and are used as handles for inserting and removing the
baffle from the WDU. The Baffle fits tightly in the WDU and may be difficult to remove and insert. The
larger wings should be on the inside of the baffle and are used to adjust water flow. For example, if there is
not enough water flow to the left side of the stone you can remove the baffle and open the left wing a little
to allow for more water to the left side.
Important: The notched edge of the baffle goes to the back of the
WDU.
6)
Now you are ready to attach the pump. First, you must remove the adhesive cover from the supplied
½” foam pad and attach it to the bottom of the pump. The bottom of the pump is determined by the
plastic nozzle pointing up. The pump pad is used to dampen the vibration of the pump and reduce
pump noise.
7)
With the hose fed down behind the stone and between the two 1 inch rubber stops attach it to the
plastic nozzle of the pump. Be sure to use the supplied hose clamp to ensure a tight fit.
Important:
Before running the pump be sure there are no kinks in the hose behind the stone.
The pump will sit in
the middle of the Water Tray with the nozzle and hose towards the back pointing up.
8)
Now fill the Water Tray with enough water to cover the pump entirely. Plug the pump power cord into a
temporary outlet or extension cord. This is for testing purposes only. You should hear the pump turn
on immediately, but it takes a few seconds for the water to start coming down the stone. Let it run for a
few minutes.