Adagio Water Features Inspiration Falls Assembly & Mounting Instructions
6 of 7
9)
Watch the WDU to make sure you are getting even water coverage across it. If you are not getting
even water coverage refer to the instructions above and make the necessary adjustments.
10)
There may be places on the stone that are dry. If this is the case just run your finger down from a wet
spot through the dry spot to get it wet.
11)
If you are getting little splashes off the face of the stone, take a flat edge screwdriver and wear away
any edges that may cause the splashing.
7. Mounting the Hood and Start Up
1)
Place the Hood over the stone with the light bar towards the front, make sure it is level and is balanced
left to right with the Water Tray. The top of the Hood should be about 1 ½ inches above the top of the
WDU.
2)
When you have it in the right location and level mark the two holes at the top.
3)
Remove the hood, pre-drill the holes with a 1/8” bit, and screw in the supplied EZ-Anchors.
4)
Place the Hood in line with the EZ-Anchors and fasten it to the wall with the pan head screws.
5)
With the hood securely fastened to the wall, coil up and hide the excess power cord behind the light bar
or the stone.
6)
If you have not already, disconnect the Pump power cord from the temporary outlet or extension cord.
Bring it up behind the stone and plug it into the light bar at the top of the Hood.
Important: No power
cords should be run through the middle notch of the Mounting Brackets. That notch is for the Pump
Hose only. The power cords should be run around the side of the Mounting Brackets.
7)
The Light Bar has a dimmer switch that can turn on or off the lights by pushing it in, and can dim or
brighten the lights by turning it to the left or right. You may use any standard size light bulb in your
water feature, but we suggest using halogen PAR 20 50 Watt flood lights.
Warning: Always turn the
fountain completely off before installing or replacing the light bulbs.
8)
Fill the Water Tray with water.
We highly recommend the use of distilled water!
If you choose not
to use distilled water we recommend the use of filtered or purified water. This will slow the build up of
hard water stains and calcification.
9)
Salt softened water will whiten or dull the stone. Reverse Osmosis softened water may be used.
Important: To avoid damaging the pump, keep the water level above highest point on the pump. Never
fill the Water Tray higher than 1 ½” below the top of the Water Tray.
10)
The last piece is the Front Splash Guard. Just above the top of the Water Tray hook one side of the
Front Splash Guard around the stone. Then carefully without scratching it hook the other side around
the stone. Then, slide the Front Splash Guard down and hook the two tabs onto the top lip of the water
tray so it hangs evenly.
Important: Make sure not to hook the Back Splash Guard with the Front
Splash Guard.
