Ada Platinum Elite, Installation Manual

Page: 8 / 48

MOUNTING THE TABLET
8. Mounting the Tablet
Ÿ
Mount the Tablet where the standard AC wall control would normally be mounted,
approximately 1.5m above floor level and preferably on an internal wall in the return air
flow. Ensure at least a 100mm ‘exclusion zone’ to any other wall mounted item.
Ÿ
If using in conjunction with a standard AC wall control, it is recommended not to mount
the Tablet below the AC control to prevent any radiant heat inadvertently affecting the AC
temperature sensor.
Ÿ
Avoid mounting in direct sunlight.
Ÿ
Avoid mounting in direct airflow of an AC vent.
Ÿ
The Mounting Plate is used as a template for marking the wall before mounting. Refer
diagram below to cut the hole required in the wall to accommodate the socket on the
back of the Tablet.
Ÿ
The Mounting Plate can be attached to a wall using or to a standard wall
switch bracket.
supplied fixings
INSTALLATION MANUAL 6 7
124 124
Plug Coms Cable into socket on
the back of the Tablet, then
simply push Tablet onto the
Mounting Plate and slide down
so it clips into place
Mounting Plate
Mounting Screw
Coms Cable
Tablet
200 200
84 84
Speaker
Factory Reset Temperature Sensor
SD Card
Power LED
Power On/Off
MOUNTING THE TABLET
NOTE: Ensure wall behind opening in
Mounting Plate is completely clear
100mm ‘exclusion zone’ to any
other wall mounted items
100 100
100 100