Models ADA FG 8, ADA FG 2x8 and ADA FG 11R require positioning on a stand or countertop with
an opening to ensure adequate air supply to the device. This is because direct oil heating is from
below. In addition, the oil drain valve is located on the bottom of the appliance.
Before installation, check that all fryer parts are included and not damaged during transport.
1. Place the appliance in a place that allows easy access from all sides, on a hard and non-flammable
surface. The distance from non-flammable walls should be at least 10 cm. If the walls are not
resistant to high temperatures, use appropriate insulation and keep a minimum distance of 30 cm.
Also keep a distance of at least 20 cm from other devices.
2. Level the appliance using the regulated legs.
Warning!
Incorrect use of the appliance can cause oil to burn and fry, which can cause severe burns, injury, as
well as fires and equipment damage.
3. Before connecting the fryer to the gas installation, check on the rating plate to which gas type the
fryer is adapted and whether it corresponds to the type of gas in the gas installation (propane-
butane B / P or natural gas E).
4. Make the connection in accordance with the following rules:
• connection to natural gas should be made:
a) rigidly using seamless pipes (steel or copper);
b) or using a metal braided hose with a CE safety certificate;
• connection of B/P from a gas cylinder should be made with a flexible hose with max. 1.5
m long, with CE safety certificate. The ends of the hose must be secured with hose
clamps.
5. A gas shut-off tap must be installed on each gas appliance and it should be easily accessible.
6. After connecting the device to the gas installation, check for leaks using appropriate sensors,
paying particular attention to the connection points. The fryer must not be put into operation after a
leak has been detected.
Warning!
Never check the tightness of the gas system with a lit match or flame. This could cause a fire or
explosion and cause serious injury or material damage. The device must not be put into operation
after a leak has been detected.
7. After completing the installation of the device, the packaging components must not be kept within
the reach of children, as they may cause hazards. Therefore, they must be disposed of (also for
environmental protection reasons) in accordance with applicable regulations.
Gas supply pipes or hoses should meet applicable national requirements and should be periodically
checked and replaced if necessary.
10
