Child Restraint Systems, Pregnancy
Tether Attachment Point
Your NSX is equipped with an
attachment point for a child restraint
system which uses a top tether. The
tether bracket and bolt are available
at your Acura dealer. The tether
attachment point is located on the
panel behind the passenger's seat-
back.
1. Adjust the passenger seat fully
forward to make room behind the
seat-back.
2. Using the dimensions shown,
measure and mark the location of
the attachment point on the
interior panel.
3. Use a razor blade or sharp knife to
carefully cut a 1 inch diameter
circle at the point you marked. Cut
through one layer at a time. You
will need to remove two layers to
reach the tether attachment.
4. Install the tether bracket and bolt
and tighten to: 16 lb.ft (22N.m)
Make sure to route the tether
through the space between the
headrest and seat.
Pregnancy
You should always wear the lap/
shoulder belt during pregnancy.
Position the lap portion as low as
possible on the hips, not across your
abdomen.
Ask your doctor if you can drive, and
about the best way to position the
lap/shoulder belt, each time you go
for a medical check-up.
Driver and Passenger Safely
