2 of 12
BII 46119 (1108)
©
2011 American Honda Motor Co., Inc. - All Rights Reserved.
6106060B
INSTALLATION
Client Information:
The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the
radio and navigation system, then write down the
radio presets.
2.
Disconnect the negative cable from the battery.
Installing the Sensors in the Bumper
3.
Open the tailgate. Remove the cargo area cover.
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Ratchet
8 mm and 10 mm Sockets
Pushpin
Drill
3 mm Drill bit
20 mm, 24 mm, and 26 mm Hole saw
Scale
Eye protection (safety goggles, face shield, etc.)
10 mm Combination wrench
File
Diagonal cutters
Utility knife
Illustration of the Back-Up Sensors Installed on the
Vehicle
BUZZER
BACK-UP
SENSOR
HARNESS
CONTROL
UNIT
CORNER
SMALL
SENSOR A CENTER
LARGE
SENSOR B
CORNER
SMALL
SENSOR A
FUSE
(2A)
5D26010B
5D26020B
4.
Remove the cargo area floor.
CARGO
AREA
COVER
TAILGATE
OPENING
TAILGATE
OPENING
CARGO
AREA FLOOR
SWITCH
Back-up Sensor Kit
2 Corner sensors A
2 Center sensors B
(with blue connector)
