©
2011 American Honda Motor Co., Inc. - All Rights Reserved.
BII 46119 (1108)
11 of 12
FRONT
46. Route the back-up sensor harness along the rear
bumper beam.
45. Reinstall the speaker.
43. Route the back-up sensor harness 4-pin connector
into the 19 mm hole, and reinstall the right quarter
pillar trim.
6106012B
FRONT
BACK-UP SENSOR
HARNESS 4-PIN
CONNECTOR
BACK-UP SENSOR
HARNESS
19 mm
HOLE
UPPER RIGHT
QUARTER
PILLAR TRIM
6 UPPER CLIPS
6106021B
19 mm
HOLE
(Switch Installation Direction)
SWITCH
BACK-UP SENSOR
HARNESS 4-PIN
CONNECTOR
SWITCH
FRONT
44. Plug the back-up sensor harness 4-pin connector
into the switch, and install the switch into the
19 mm hole in the direction shown.
6106030B
47. Attach the seven harness clips to the back-up
sensor harness. Three of the clips attach at the
green-taped locations. Using isopropyl alcohol on
a shop towel, clean the rear bumper beam where
the harness clips attach. Remove the adhesive
backings from the seven harness clips, and attach
them to the rear bumper beam in the area shown.
Start at the center and work your way outward on
each side.
4 HARNESS
CLIPS
REAR BUMPER
BEAM
ADHESIVE
BACKING
REAR BUMPER
BEAM
FRONT
3 HARNESS
CLIPS
REAR BUMPER
BEAM
ADHESIVE
BACKING
BACK-UP
SENSOR
HARNESS
BACK-UP SENSOR
HARNESS
GREEN
TAPE
BACK-UP
SENSOR
HARNESS
BACK-UP
SENSOR
HARNESS
