ACU-RITE 200S READOUTS, Reference Manual

Page: 28 / 82

14 I
I - 2 Gener
a
l Oper
ations f
o
r 20
0S
Status Bar Settings
The Status Bar is the segmented bar at the top of the screen which
displays current datum, tool, feed rate, job clock and page indicator.
 Press the ON/OFF soft key for each setting you want to
see displayed.
Job Clock
The job clock shows the hours (h), minutes (m), seconds (s). It
operates like a stop watch showing elapsed time. The clock starts
timing from 0:00:00.
„
The elapsed time field shows the total accumulated time from
each interval.
 Press theSTART/STOP soft key, the status field will read RUNNING.
Press it again to stop time from elapsing.
 Press RESET to reset the elapsed time. Resetting will stop the
clock if it is running.
Remote Switch
The remote switch sets the parameters so the external switch
(pendant, or foot switch) can be enabled to perform any or all of the
following functions: Data Output; Zero, and Next Hole. Refer to
Section II for information on connecting remote switches via
Grounding Edge Finder input.
„
Data Output - to send position information out of the serial port or to
print the current position.
„
Zero - to zero one or more axes. In Distance-To-Go mode, it will zero
the Distance-To-Go display. In Actual Value mode, it will zero
the datum).
„
Next Hole key press will move to the next hole within a pattern (i.e.
Hole Pattern).
 While in the Data Output Field, press the ON/OFF soft key to ON
to send the current position over the serial port when the switch
is closed.
Pressing the Decimal key while in operating mode, will
also stop and start the clock. Pressing the Zero key will
reset the clock.