16
DoorLIFT DL
-
6
Remote door system
4.
Ensure the cable is still 50mm past the release
lever in the motor housing and the lever is still
engaged. Using good quality cutters cut the
cable 25mm below the lock mounting plate. Not
using a proper tool to cut the stainless cable can
cause the end of the cable to fray and become
difficult to insert into the lock cylinder.
5.
Slide the red tube, the 60mm piece of cable
sleeve and the plastic cover base over the cable.
Push the cable through the door and lock
housing so it protrudes through the face
6.
Insert the cut end of the cable into the hole on
the back of the lock core. Secure the cable by
tightening the set screw on the side of the core
with a 2mm Allen key. Be sure it is as tight as
possible. Insert the core into the housing, turn
90 degrees, and remove the key.
Installation guide
