Activa SmartMop, User Manual

Page: 9 / 14

OFF
1
1
2
2
5
6
5
7
6
3
4
3
4
8
7
8
AT THE END OF THE WORK
At the end of the work, and before carrying out any type of
maintenance, perform the following operations:
1. Deactivate the appliance using the main switch (1) (Fig.1).
2. Rotate the handlebar so it is vertical.
ATTENTION:
during this operation, do not rest your foot on
the appliance.
3. Raise the squeegee off the floor and rotate the knob (2) in the
direction of the arrow (Fig.2).
7. Rotate the front carter (5) as far as it will go - do this with the
aid of the handle (6) (Fig.5).
ATTENTION:
these operations must be carried out using
protective gloves to avoid any possible contact with the
edges or tips of metal objects.
8. Remove the recovery tank (7) from the appliance( Fig.6).
9. Remove the recovery tank cover (8) ( Fig.7).
15. Remove the detergent solution filling cap (9) from its seat on
the solution tank (Fig.9).
16. Empty the tank.
17. Rinse the inside of the tank with a jet of water.
18. Replace the de, ergent solution filling cap (9) in its seat on
the solution tank (Fig.10).
ATTENTION: Fig. 2 shows the Ieft side of the device.
Rotate the knob on the right-hand side in the opposite
direction.
4. Take the appliance to the dedicated waste water drainage
area.
ATTENTION:
The place given over to this operation must
comply with current environment I protection regulations.
5. Remove the power battery (3) from the appliance. To free
the battery, shift the stop lever (4) in the direction of the
arrow(Fig.3).
6. Remove the battery from the appliance using the handle
moulded on it (Fig.4).
ATTENTION: protective gloves should always be worn
before handling detergents or acidic or alkaline solutions,
to avoid serious injury to the hands.
10. Empty the tank.
11. Rinse the inside of the tank with a jet of water. If necessary ,
use a spatula to remove the sludge that has accumulated at
the bottom.
12. Position the recovery tank cover (8) on the tank.
13. Fix the cover on the tank.
14. Remove the solution tank from the device (Fig.8) .
19. Insert the two tanks in the appliance, positioning first the solution
tank and then the recovery tank.
20. Rotate the front carter (5) as far as the work position - do this
with the aid of the handle (6) (Fig.11).
21. Block the handlebar in the horizontal position (Fig.12).
!
!