24
33
34
35
18
366
27
28
41
25
42
Careful maintenance of the squeegee rubbers guarantees better
cleaning and drying of the floor, as well as a longer vacuum motor
life. To replace the squeegee rubbers, proceed as follows:
• Tum the wing nuts (24) that hold the squeegee by 90°
(Fig.33).
•
Remove the squeegee from the slots on the squeegee
connector, taking care not to lose the seal on the vacuum
nozzle (Fig.34).
ATTENTION:
Fig.37 shows the left side of the device. Rotate
the knob on the right-hand side in the opposite direction.
38.
Remove the exhaust air filter support (25) from the appliance by
pressing the fixing tab (26) in the direction of the arrow (Fig.38).
39.
Clean the filter cartridges (27) with a jet of air (Fig.39), from a
distance of at least 20 cm.
• Replace the worn/damaged rubber.
• Repeat the operations in reverse order to reassemble all the
parts.
36.
Bring the squeegee coupling to the idle position and shift the
squeegee towards the appliance (Fig.35).
37.
Fix the squeegee coupling in the idle position. Push the knob (18)
towards the appliance (Fig.36), then rotate it in the direction of
the arrow (Fig.38).
Careful maintenance of the exhaust air filters guarantees a longer
vacuum motor life. To replace the filter cartridges, proceed as
follows:
•
Remove the filter cartridge supports (28) from the filter
support (Fig.40).
•
Remove the wom filter cartridge (27) from the filter cartridge
support (28) and replace it with the new one (Fig.41).
•
Repeat the operations in reverse order to reassemble alt the
parts.
43.
Rotate the front carter (4) as far as it will go - do this with the aid
of the handle (5) (Fig.45).
44.
Insert the two tanks and the detergent solution filter cartridge
in the appliance, positioning first the detergent solution filter
cartridge, then the solution tank, and finally the recovery tank.
45.
Rotate the front carter (4) as far as the work position - do this with
the aid of the handle (5) (Fig.46).
40.
Insert the exhaust air filter support (25) in the appliance (Fig.42).
41.
Rotate the appliance to its work position (Fig.43).
42.
Block the handlebar in the vertical position; to release the
handlebar, move the stop in the direction of the arrow (Fig.44).
46.
Insert the battery in the battery-holder compartment in the rear
part of the appliance (Fig.47).
47.
Position the appliance with its rear part in contact with the floor
(
Fig.
48).
ATTENTION:
Park the appliance in an enclosed place, on a
flat surface; near the appliance there must be no objects that
could either damage it, or be damaged through contact wilh it.
48
47
4
5 5
4
45
46
28
460
27
27
39
26
25
38
18
37
!
5
4
464
43
Summary of Contents for SmartMop
Page 1: ...User Manual Activa SmartMop ...
Page 14: ......
