PREPARING TO WORK
Before beginning to work, it is necessary to:
ATTENTION:
before beginning the first work cycle , fully
recharge the battery (read "RECHARGING THE BATTERY").
1. Before using the appliance, make sure it is in a good , safe
working condition. If everything is not in order, the appliance
must not be used.
2. Rotate the handlebar so it is vertical.
ATTENTION:
during this operation, do not rest your foot on
the appliance.
3. Activate the appliance using the main switch (1) (Fig.1).
ATTENTION:
if the LED of the main switch (1) (Fig.1)
is lit up,this means the electrical system of the appliance
is activated.
4. Check the battery charge level. There are four LEDs (2) on the
battery to show the charge percentage (Fig.2). If all the LEDs
are lit up, the battery is fully charged; if they are all switched
off,the battery is completely run down.
5. Deactivate the appliance using the main switch (1) (Fig.3).
6. Remove the power battery (3) from the appliance. To free the
battery, shift the stop lever (4) in the direction of the arrow
(Fig.4).
7. Remove the battery from the appliance using the handle
moulded on it (Fig.5).
8. Make sure the condition of the squeegee rubbers is suitable
for the work you want to carry out . If it isn't , perform the
necessary maintenance (read "MAINTENANCE").
9. Make sure the condition of the brush is suitable for the work
you want to carry out . If it isn't , perform the necessary
maintenance(read " MAINTENANCE").
10.Rotate the front carter (5) as far as it will go - do this with the
aid of the handle (6) (Fig.6).
ATTENTION:
these operations must be carried out using
protective gloves to avoid any possible contact with the
edges or tips of metal objects.
11. Remove the solution tank from the device (Fig.7). Carefully
place it on the foor.
12. Remove Ihe detergent solution filling cap (7) from its seat
on the solution tank (Fig.8).
13. Fill with clean water, at a temperature no higher than 50
℃
and no lower than 10
℃
.
14.
Add the liquid detergent to the solution tank in the
concentration and manner indicated on the detergent
manufacturer's label.
ATTENTION:
the formation of excess foam could
damage the vacuum motor, so use only the minimum
amount of detergent necessary.
ATTENTION:
always use detergents whose manufacturer's
label indicates their suitability for scrubbing machines. Do
not use acid or alkaline products or solvents without this
indication. Acid or alkaline maintenance detergents can be
used, as long as they have pH values between four and ten ,
and do not contain oxidising agents, chlorine or bromine,
fonnaldehyde, mineral solvents.
ATTENTION:
protective gloves should always be worn
before handling detergents or acidic or alkaline solutions,
to avoid serious injury to the hands.
ATTENTION:
always use low-foam detergent. To avoid the
production of foam, put a minimum quantity of antifoam liquid
in the recovery tank before starting to clean. Do not use pure
acids.
15. Replace the detergent solution filling cap (7) in its seat on
the solution tank (Fig.9).
ATTENTION:
it is good practice to empty the recovery
tank every time you top up the solution tank level.
16. Insert the solution tank in the device (Flg.10).
17. Rotate the front carter (5) as far as the work position - do
this with the aid of the handle (6) (Flg.11).
18. Insert the battery in the battery-holder compartment in the
rear part of the device.
7
8
7
5
6
3
5
6
3
2
4
OFF
1
3
2
2
ON
1
1
!
!
Summary of Contents for SmartMop
Page 1: ...User Manual Activa SmartMop ...
Page 14: ......
