9
10.
Get the
yellow Ethernet cable
from the kit and plug one end into a
yellow Ethernet port
on the back
of the Gateway, then click
Next
.
11.
Plug the other end of the
yellow Ethernet cable
into an
Ethernet port
on the back of the computer.
Click
Next
.
?
Note
: An Ethernet port looks similar to a phone jack, but is slightly larger.
13 Chapter 2 Setting Up the Gateway
12.
Make sure one of the
Ethernet lights
on the front of the Gateway
glows solid green
. Click
Next
.
13.
Get the
black or gray DSL cable
from the kit and plug one end into the
gray Line port
on the rear
panel of the Gateway. Click
Next
.
14 Actiontec 54 Mbps Wireless DSL Gateway User Manual
14.
Plug the other end of the
black or gray DSL cable
into the
phone jack
closest to the computer. Click
Next
.
The Gateway is connected to a computer via Ethernet. Next, install the filters as described in “Installing
Filters” on page 22.
Connecting Via USB
1.
Insert the Installation
CD
in the
CD-ROM
drive of the computer. The Installation Buddy starts
automatically. Wait until the following screen appears, read the on-screen instructions, then click
Next
.
15 Chapter 2 Setting Up the Gateway
2.
Read the instructions, select
Initial Setup
by clicking on the appropriate check box, then click
Next
.
3.
Click the check box next to
USB
, then click
Next
.
16 Actiontec 54 Mbps Wireless DSL Gateway User Manual
4.
Make sure the items needed to connect the Gateway to the first computer are included in the kit, then
click
Next
.
5.
Get the
Gateway
from the kit, then click
Next
.
17 Chapter 2 Setting Up the Gateway
6.
Get the
Power cord
and plug the smaller end into the
black Power port
on the rear panel of the
Gateway, then click
Next
.
7.
Plug the larger end of the
Power cord
into a
power outlet
, then click
Next
.
18 Actiontec 54 Mbps Wireless DSL Gateway User Manual
8.
Click the
On/Off switch
to its on position (as shown in the picture on-screen), then click
Next
.
9.
Confirm the
Power light
on the front of the Gateway
glows solid green
, then click
Next
.
19 Chapter 2 Setting Up the Gateway
10.
Get the
blue USB cable
from the kit and plug the square end into the
blue USB port
on the back of the
Gateway, then click
Next
.
11.
Plug the rectangular end of the
blue USB cable
into an
USB port
on the front or back of the computer.
Click
Next
.
