13
The sweep can be performed decreasing or increasing the frequencies, depending on the
last manual search performed
If no button is pressed the frequency sweep continuous
If [SCAN/MEM] key is pressed again the current frequency is selected
If RDS is ON, only RDS stations can be detected during the SCAN or SEEK process
Select a memorized RADIO station
Selection of the memorized station is performed by pushing [1] to [6] keys
Clock
By pushing [DISP] key the information [CLOCK] or [RADIO FREQ] are displayed .
Clock can only be adjusted by holding [DISP] key more than 3s, the message [RDS CLOCK
ON/OFF] appears:
o
if ON, the RDS system will automatically store the time information.
o
if OFF, each field (HH, MM, SS) will blink each time [DISP]
key is pushed. The
adjusted is performed by turning the VOL key.
RDS TA Mode
Traffic Announcement system: this function will search for a station which is transmitting TA
messages. While this station is not found, the radio will still keeps searching.
To enable/disable the TA function push [MODE/TA] key till you see the icon turns on/off on
the LCD.
RDS AF Mode
Alternative Frequency: this function will search for a radio station alternative frequency when
the current frequency can no longer be tuned. If no alternative frequency is found, the radio
will stop searching after a while.
To enable/disable the TA function hold [BAND/AF] key for 3s till you see the icon turns on/off
on the LCD.
3.4. MICROPHONE SOURCE (MIC)
Source selection
The
MIC
audio source is automatically selected for both PASSENGER and DRIVER when the
ACTIA MICROPHONE pin is switched on. When the pin is switched off, the equipment comes
back to the previous selected source.
Auto Pause/Play
If in the moment of the MIC selection there was a song or movie being played, this playback will
be temporally paused and will return to previous status when the MIC is switched off.
Auto Power on equipment
If equipment is on stand-by and microphone pin is switched on, the equipment powers on
automatically and select directly the MIC audio source for both areas. If no other action is
performed and the mic pin is switched off, the equipment comes back to stand-by status.
Volume Adjust
The microphone volume is independent from the General volume of the remaining sources and
also individual for DRV and PSG areas. So that once you configure the adequate level you don’t
need to be disturbed to adjust it again for each time you use the microphone.
Mic DRIVER and GUIDE Priority
