![background image](http://html1.mh-extra.com/html/acti/pmax-0318/pmax-0318_installation-manual_2842765009.webp)
www.acti.com
Hardware Manual
9
2.
Using the four (4) screws bundled with the Wall Mount, install the camera to the wall mount
with the screw holes marked as
“
2
”.
Step 3: Manage the Cables
1.
Route the cables from the network side through the hole on the wall and connect the Ethernet
cable to the Ethernet port of the camera. If using a power adapter, you may also connect it to
the camera power connector, at this point.
2.
Check if the connection is working. If ok, then wrap the cable connections with waterproof
tape to protect the cables from water or other environmental factors. Note that, waterproofing
must be done from the yellow label towards the connectors.
DISCLAIMER:
Make sure to apply proper waterproofing method to the cable connectors.
ACTi will not be responsible for camera damage caused by improper waterproofing
application, improper installation or the misuse of equipment for installation.
c
Ethernet
DC12V Power