61
Marvair Scholar 2.0 I&S Manual 08/2021 Rev.2
HOLES TO SECURE BASE STAND TO FLOOR
HOLES TO SECURE SCHOLAR 2.0 STAND TO BASE STAND
Figure 1. Top View of Base Stand
Also, recheck the locations of the electrical and condensate stub-outs to ensure they are
located properly, relative to the cabinet knock-out openings as shown in the
Installation and Start-Up Manual, Figures 3 and 4.
IMPORTANT
STUBOUTS SHOULD BE LOCATED (FROM THE FLOOR OR WALL) TO ALIGN WITH
SELECTED CABINET KNOCK OUT ON THE CABINET, AS SHOWN IN FIGURE3.
THIS IS A REQUIREMENT IF A BASE STAND IS TO BE INSTALLED AND STUBOUTS
ARE COMING THROUGH THE FLOOR
Lastly, remeasure to be sure that the wall opening for the Scholar 2.0 heat pump and air
conditioner air box is located properly, taking the height of the base stand into account,
before proceeding to install the base stand.
1.03 INSTALLATION
After the base stand is located on the floor, mark the floor in the locations where 1/2”
through holes go through the bottom flange of the base stand. Be sure the floor is a hard,
smooth surface and the base stand is level. If the floor is carpeted, cut out a base stand
“footprint,” so the base stand rests on the non-carpeted floor.
Anchor the base stand to the floor with the four field supplied anchors.
Now remove the lower front cabinet panel from the heat pump or air conditioner, removing
the shipping skid bolts, air box support and installing the plenum (as appropriate), following
the instructions provided in Appendix C.
