Marvair Scholar 2.0 I&S Manual 04/2022 Rev.2
24
Item # Part #
Description
Qty
1
SMV15003X
SNOUT BOTTOM
2
2
SMV15007X
SNOUT LH/RH SIDE
2
3
SMV15013X
36” SNOUT BOTTOM
2
4
SMV15016X
CENTER SNOUT SIDES
2
5
SMV45058X
ODS BRACKET
2
6
N/A (not shown)
POP-IN WIRE TIE
4
7
N/A
0.5 INCH PLASTIC BUSHING.SLDASM
2
8
N/A
THERMOCOUPLE
2
9
SMV15030X
SUPPLY AIR BLOCKOFF
2
10
SMV15027X
SNOUT DISCHARGE AIR UPPER DIVERTER
1
11
SMV15026X
SNOUT DISCHARGE AIR LOWER DIVERTER
1
12
SMV15032X
SNOUT FRESH AIR INLET DUCT
2
13
SMV15028X
SNOUT DISCHARGE AIR LOWER DIVERTER
1
14
SMV15029X
SNOUT DISCHARGE AIR UPPER DIVERTER
1
15
SMV15031X
SNOUT FRESH AIR INLET DUCT EXTENSION
1
2.10 INSTALLATION THROUGH THE OUTSIDE WALL
A. Slide the Scholar 2.0 heat pump or air conditioner into the wall opening slowly, being
careful to clear the appropriate stubouts. The heat pump or air conditioner, when
installed properly, should have a clearance between the air box outside edge and
the finished outside wall as shown in Figure 4. Proper fit up of the louver/collar
assembly to the air box to the outside wall requires the noted recess dimension to be
maintained after installing the unit.
B. To minimize sound in the classroom, insulate all four sides of the outdoor air box that
is internal to the classroom with the following:
• Layer 1: 1/2” Rubatex
• Layer 2: 1-1/2: Duct Board
FREEBLOW PLENUM
SCHOLAR III™
HEAT PUMP OR
AIR CONDITIONER
DISTANCE (INCHES) BETWEEN AIR BOX
AND OUTSIDE FINISHED WALL
LOUVER/COLLAR
OUTSIDE WALL
NOTE: TO PREVENT RAIN WATER FROM RUNNING
DOWN THE INTERIOR OF THE WALL, INSTALL FLASHING UNDER
THE OUTDOOR AIR BOX OVER THE SILL OF THE WALL OPENING.
Figure 5. Dimension Between Scholar 2.0 Heat Pump or Air Conditioner Air Box and Finished
Outside Wall for Outdoor Louver/Collar Assembly Installation
