Marvair Scholar 2.0 I&S Manual 08/2021 Rev.2
60
APPENDIX C - BASE STAND INSTALLATION
1.01 TOOLS/FIELD FURNISHED SUPPLIES
WARNING
TO AVOID PERSONAL INJURY, ADEQUATE PROTECTIVE CLOTHING MUST BE WORN
AND PRECAUTIONS IN HANDLING AND INSTALLING THIS EQUIPMENT MUST BE
PRACTICED AT ALL TIMES.
• Power Drill/Driver and Extension
• Bit for 5/16” Hex Head Bolts (or Adjustable Wrench)
• Appropriate Bits for Boring Anchor Holes and Fastening Anchor Bolts Through 1/2” Pass
Through Holes in Base Stand (4 Locations)
1.02 INSPECTION/UNPACKING/HANDLING
Base stands are shipped to the job site on wooden skids and are enclosed in shrink wrap.
Do not stack the base stands.
IMPORTANT
IMMEDIATELY UPON RECEIPT, INSPECT THIS EQUIPMENT TO DETERMINE
VISIBLE AND CONCEALED DAMAGE. ALL DAMAGE MUST BE REPORTED TO THE
FREIGHT CARRIER WITHIN 15 DAYS, ON THE FREIGHT CARRIER’S FORM.
The label on the base stand identifies the part number of the base stand.
Base Stand
Height
Part Number
2”
S/06849
4”
S/06850
Remove the shrink wrap from the base stand and dispose of the wooden skid. Retain
the bag of 5/16” bolts and flat washers to fasten the cabinet to the base stand.
Do not
install the Scholar 2.0 heat pump or air conditioner to the base stand at this time.
Place the base stand (as shown in Figure 1) on the floor, measuring carefully to determine
the exact location, based on where the heat pump or air conditioner is intended to be
placed. It is important to be sure of base stand location when the unit is going to be located
set off from the finished inside wall. The unit will be located directly on top of the base
stand, and the base stand will be anchored to the floor.
