When the password is set, you are asked to enter it. If the password you entered does not
coincide with the setting, you cannot change the setting values.
You may select any 4-digit number from 0001 to 9998 as your password.
Note: Numbers "0000" and "9999" are not valid as password.
All settings must be reset if you forget the password. Refer to "8. Resetting"
.
Push the [SETTING START/END] button before you start setting. At that moment,
" " is indicated on a display and you go into setting mode.
Example Set the password "1234".
Setting the Password
1
Push the [FUNCTION] button for 2
seconds.
2
Once a number on the display starts
flashing, position the " " mark over
the "PASSWORD" mark by pressing
the [FUNCTION] button.
A flashing number can be changed.
4
Change the last two digits.
Next, push the [+] or [-] button to
set at "34" and then, push the [SET]
button. At that moment, the display
will change from flashing to steady,
and the setting is now completed.
5
Push the [SETTING START/END]
button to get out of setting mode.
Make sure "date" and "time" are
indicated on the display and the
colon is flashing. Then replace the
cover and lock.
3
Change the first two digits.
In case of the example, push the [+]
or [-] button to set at "12" and then,
push the [SET] button. At that
moment, flashing of the display will
change to the last two digits.
59
SET
FUNCTION
PASSWORD
SET
FUNCTION
PASSWORD
SET
FUNCTION
PASSWORD
AM
Colon
Date
53
Summary of Contents for ES1000
Page 1: ...USER S MANUAL ...
