Acromag, Inc. Tel: 248-295-0880
- 35 -
Model SP33X-0700
4-Wire DC I/V Signal Splitter w/USB
Power
Enclosure & Physical
Power Supply (Connect at TB5 or via DIN Rail Bus Terminal):
6-32V DC SELV (Safety
Extra Low Voltage), 1.5W maximum. Observe proper polarity. Reverse voltage
protection is included. Current draw varies with power voltage as follows (currents
indicated assume maximum load with both current outputs driving 20mA into 500Ω).
SUPPLY
SP33X-0700 CURRENT CONSUMPTION
6V
221mA Typical / 250mA Max
12V
105mA Typical / 125mA Max
15V
84mA Typical / 100mA Max
24V
53mA Typical / 62mA Max
32V
41mA Typical / 46mA Max
CAUTION:
Do not exceed 36VDC peak to avoid damage to the unit. Terminal voltage
at or above 6V minimum must be maintained across the unit during operation.
Power Supply Effect:
Less than
0.001% of output span effect per volt DC change.
General purpose plastic enclosure for mounting on 35mm “T
-
type” DIN rail.
Case Material:
Self-extinguishing polyamide, UL94 V-0 rated, color light gray.
General purpose NEMA Type 1 enclosure.
Circuit Board:
Military grade fire-retardant epoxy glass per IPC-4101/98.
Unit Weight:
0.35 pounds (0.16 Kg).
Dimensions
: Width = 17.5mm (0.69 inches), Length = 114.5mm (4.51 inches), Depth
= 99.0mm (3.90 inches). Refer to Mechanical Dimensions drawing.
I/O Connectors:
Removable plug-in type terminal blocks rated for 12A/250V; AWG
#26-12, stranded or solid copper wire.
Program Connector:
5-pin, Mini USB B-type socket, Hirose UX60-MB-5S8.
DIN-Rail Mounting:
Unit is normally mounted to 35x15mm, T-type DIN rails. Refer
to the DIN Rail Mounting & Removal section for more details.
LED Indicators (Front-Panel)
Power PWR (Green)
–
Channel Green ON indicates power is applied to unit (this LED
is sourced from isolated internal 3.3V rail).
Fault FLT - Channel Output (Orange, Each Output, FLT1 & FLT2) -
Orange FLT LED per
output channel. ON indicates current output is open circuit, or the corresponding
current output load resistance is too high to drive accurate current to it (load
resistance is greater than 550Ω). ON may also indicate over
-temperature if the
output driver die temperature has exceeded 142°C.
Environmental
These limits represent the minimum requirements of the applicable standard, but this
product has typically been tested to comply with higher standards in some cases.
Operating Temperature:
-40
C to +75
C (-40
F to +167
F).
Storage Temperature:
-40
C to +85
C (-40
F to +185
F).
Relative Humidity:
5 to 95%, non-condensing.
Isolation:
Input/USB, each output, and power circuits are all isolated from each
other for common-mode voltages up to 250VAC, or 354V DC off DC power ground,
on a continuous basis (will withstand 1500VAC dielectric strength test for one minute
without breakdown). Complies with test requirements of ANSI/ISA-82.01-1988 for
voltage rating specified.