3-24
Factory Default
In this section, you can reset the switch to its default settings as shown below:
Default IP address:
192.168.10.1
Default Gateway:
192.168.10.254
Subnet Mask:
255.255.255.0
Other switch settings will be set to “disable” or “none”.
Click on
Default
to reset your switch to its default settings as shown above.
Note:
This provides a quick method for clearing the switch’s internal settings. However, it will not
restore the IP address to the default setting. If you want to restore all the settings to their default
state, including the IP address, please use the reset button on the front panel of your switch
(refer to the Reset Button section).
System Reboot
System Reboot allows you to reset the switch software. Click
Reboot
to reboot your switch
software.
Note:
Always remember to click on the
Save Configuration
button to save your settings.
Otherwise, the settings you made will be lost when the switch is powered off.
Save Configuration
Save Configuration allows you to save your configuration to non-volatile flash memory. Powering
the switch OFF without clicking Save Configuration will cause any new settings to be lost. After
selecting Save Configuration, click on the
Save Flash
button to save your new configuration.
