2-6
DIN-Rail Mounting Installation
The DIN-Rail clip is attached to the rear of the switch via two screws. This clip may be removed
for surface or wall mounting. If the DIN-Rail clip is not already attached, follow these instructions
to attach the DIN-Rail clip.
1. Use the two screws provided to attach the DIN-Rail clip to the rear panel of the switch where
shown below (note that the spring side of the DIN clip is positioned at the top).
2. For flat surface or wall mounting, you can remove the DIN-Rail clip in similar fashion.
Follow these steps to mount the switch to the DIN-rail track.
1. Insert the upper end (spring side) of the DIN-rail clip onto the upper lip of the DIN-rail track as
shown below.
2. Push the bottom of the switch inward by tilting it downward until it snaps onto the track.
Check that the unit is firmly secured to the track.
3. To remove the Switch from the track, push downward on the unit to compress the spring,
and pull the bottom outward from the track to disengage the unit and lift it off the track.
