16
first interface can set the DI1 / DI2 linkage closing opening, mode setting, channel opening, and
the execution of channel action.
If you only need to open the linkage function of part of the channel, you need to set the channel
to be controlled (1 is enabled, 0 means the channel is not enabled).
If you need to control the action of some channels, some channels are divided, you need to
enter the third interface to set the corresponding channel action (1 means that the channel is enabled,
0 means that the channel is not enabled).
Note: "Yes" means that DI linkage is on and "No" means that DI linkage is off.
"01" means the corresponding DI detects the incoming signal action; "010" means the detected
action when the signal comes and moves again when the signal is removed.
Example 3: Set DI1 linkage, DI1 and 13-24 channels; 1-12 channels and 13-24 channels.
(Mode is set to 010)
After the setting is completed, press MENU to return until whether to save the setting interface, select "Yes" by
pressing the left or right button, and press Enter to confirm the saving of data and exit the setting interface.
5.3.7 RS485 communication settings
Press MENU to enter the programming password interface: press the flip key and left or right
key, enter the user password (the default password is 0001), and press the enter key to enter. After
the password is correct, enter the programming interface. Press the left button or the right button
Press the MENU
key
After entering the
password,
press
the Enter key to
Press the
left key or the
right
key
to
select
the
linkage setting,
Press the left
button or, the right
button and the return
button to set the
parameters, press the
Press the page
Press the
flip button to
enter the third
interface,
Press the page
Press the
left key or the
right key to select
Communication
Settings,
and