COPYRIGHT 2010 - 2020, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
OMNICYCLE
®
ELITE USER MANUAL
29
Analysis of Session Data:
At the end of an exercising session, an analysis of the session data is displayed (Exercise
Summary). The data is only calculated if the session has lasted for at least one minute and was started by pressing
the START button. The following data is displayed:
•
Duration
: total length of exercising session (in minutes) excluding “PAUSE”
•
Active proportion
(patient’s efforts): proportion of the total time (in %) during which the patient was
exercising by his/her own efforts.
•
Activity, left
: proportion of activity for the left leg (in %).
•
Activity, right
: proportion of activity for the right leg (in %).
•
Distance
: total distance completed (in km).
•
Number of spasms
: number of spasms detected during the exercising session.
•
Calories
: number of calories consumed (in kcal).
•
Starting motor power
: assistance (muscle hypertonia) at the start of the exercising session (during the first
60 seconds)
•
Finishing motor power
: assistance (muscle hypertonia) at the end of the exercising session
Pressing the “STOP” button takes you back to the basic display.
Resetting the Basic Exercise Settings/Defaults:
The Omnicycle
®
Elite is delivered with default settings. The cycle
also has the ability for the user to set predetermined default settings using the “Set Params” setting in the Selection
Menu.
If any settings are changed on the Selection Menu, without setting them to default, those changes are retained until
the power is switched off, power has been disconnected, or the settings are changed manually. This means that the
same settings can be used for the next exercise session until changed or power has been interrupted.
If you wish to reset the Omnicycle
®
Elite to the user predetermined setting, proceed as follows:
•
Press the “Reset to Default” button to reset the Omnicycle
®
to restore user default settings.
•
The Omnicycle
®
Elite will revert to the user predetermined default settings, and the display will read
“Reset to Default”.
If you wish to reset the Omnicycle
®
Elite to the factory settings, proceed as follows:
•
Press and hold the “STOP” button, while pressing the “Reset to Default” button to reset the Omnicycle
®
to
restore default settings.
•
The Omnicycle
®
Elite will revert to the factory default settings, and the display will read “Settings
Restored”.
Biofeedback Program Levels:
SOCCER EXERCISE LEVEL
MINIMAL
MODERATE
MAXIMUM
Ball size
Big
Medium
Small
Ball speed
Slow
Faster
Fastest
Active RPM Range required to position the goalie in
the net
20-35
30-45
40-70
Assisted RPM Range placing the goalie below the new
1 -15
1-25
1-35
TRAFFIC JAM EXERCISE LEVEL
MINIMAL
MODERATE
MAXIMUM
Number of vehicles
0
1
2
PORCUPINE EXERCISE LEVEL
MINIMAL
MODERATE
MAXIMUM
Rate of descent falling target
Slow
Faster
Fastest
