ACP MenuMaster RFS Subway, Service Training Manual

Page: 9 / 36

7
Unpacking Oven
• Inspect oven for damage such as dents in door or
dents inside oven cavity.
• Report any dents or breakage to source of purchase
immediately. Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a
few hours before connecting power.
Radio Interference
Microwave operation may cause interference to radio,
television, or similar a oven. Reduce or eliminate
interference by doing the following:
• Clean door and sealing surfaces of oven according to
instructions in “Care and Cleaning” section.
• Place radio, television, etc. as far as possible
from oven.
• Use a properly installed antenna on radio, television,
etc. to obtain stronger signal reception.
Oven Placement
• Do not install oven next to or above source of heat,
such as pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could
shorten life of electrical parts.
• Do not block or obstruct oven filter. Allow access for
cleaning.
• Install oven on level countertop surface.
A — Allow at least 1½ inches / 3.81 centimeters of
clearance around top and sides of equipment.
Proper air flow around equipment cools electrical
components. With restricted air flow, oven may
not operate properly and life of electrical parts is
reduced.
Oven Clearances
Installation
A
A
A
B