ACP MAX-Tension TL-2, Training And Product Installation Manual

Page: 26 / 36

July 2020 | Page 26 NSW/WA/SA/ACT 02 8708 4400 VIC/TAS 03 8773 5300 QLD/NT 07 3442 6200 www. acprod .com.au
Product & Installation Manual: MAX-Tension
TM
TL-2
13.4 Loosen (if not already loosened) the front
cable assembly nuts at the foot of the ground
strut as shown below.
13.5 Slide the front bottom edge of the yellow
nose cover that contains the two cables slots
over the threaded rods ensuring the nuts and
washers are on the outside, as shown below.
Retighten the cable assembly nuts.
13.6 Fix two self-drilling hex head screws
(supplied with kit hardware) through the yellow
nose cover and into the predrilled holes of the
impact head on the traffic side only, as shown
below.
13.7 Lastly, if not already done, place the
appropriate delineation chevron that is in
accordance with the local state delineation
guidelines on the front flat surface of the yellow
nose cover.
13.8 Tighten all hardware.