20
Fields in this page:
Field
Description
Disable WPS
Check to disable the Wi-Fi protected Setup.
WPS Status
When AP’s settings are factory default (out of box), it is set to open security and
un-configured state. “WPS Status” will display it as “UnConfigured”. If it already
shows “Configured”, some registrars such as Vista WCN will not configure AP. Users
will need to go to the “Backup/Restore” page and click “Reset” to reload factory
default settings.
Self-PIN Number
“Self-PIN Number” is AP’s PIN. Whenever users want to change AP’s PIN, they
could click “Regenerate PIN” and then click “ Apply Changes”. Moreover, if users
want to make their own PIN, they could enter four-digit PIN without checksum and
then click “ Apply Changes”. However, this would not be recommended since the
registrar side needs to be supported with four-digit PIN.
Push Button
Configuration
Clicking this button will invoke the PBC method of WPS. It is only used when AP acts
as a registrar.
Client PIN Number
It is only used when users want their station to join AP’s network. The length of PIN
is limited to four or eight numeric digits. If users enter eight-digit PIN with checksum
error, there will be a warning message popping up. If users insist on this PIN, AP will
take it.
Function buttons in this page:
Regenerate PIN
