-
In mode 1 to 8 – selection of the proper four-digit code by means of the keypad. The first of the codes is code
No. 1 in the Table of Codes, the second code is code No. 2, etc.
According to the factory settings, all the codes activate only
Output 1
(activity time of
Output
2 = “0”).
When the activity time of
Output 2
is other than “0”, the codes with uneven ordinal numbers (1, 3, 5,…) activate only
Output 1
, and those with even ordinal numbers (2, 4, 6,…) only
Output 2.
There is also a possibility to switch on the so called “Double Key” mode, which makes the control of two outputs (only in
the mode of 255 codes) possible with the use of the same code. The operation of the mode consists in selection of the
code ordinal number from the keypad, then, depending on whether we press the push-button (key) once or twice, after
the proper four-digit code is entered, output 1 or output 2 will switch on (output 1 – we press 1 x [key]; output 2 = we
press 2 x [key]).
The codes entered by the manufacturer are included in the attached “Table of Codes” (items from 1 to 255), and each
code can be changed (programme 2 in the setting programming function). It is also possible to set the so called code
“Shifts” known from other ACO products (among other things, doorphone control unit), which causes the addition of the
numerical value (from 1 to 998) to the code ordinal number (only for the mode of 255 codes). Owing to setting, the
same shift value and the same Table of Codes, we can reproduce the codes and exactly the same method of their
selection as in the ACO doorphone control units.
The lock has the INPUT, which causes the activation of
Output 1
by shorting with the use of an optional push-button.
The input is protected from continuous short-circuit.
DIAGRAM OF CONNECTIONS
3. PROGRAMMING OF THE LOCK SETTINGS – installation programming
It is possible to change the operating parameters of the lock by means of programming. The access to the programming
mode of lock settings is protected by an installer password. All the settings are saved in the read-only memory and are
not subject to loss after switching off and on the power supply.
In order to enter the programming mode of the lock settings (installation programming) press push-button [
key
] and
enter an eight-digit password [1507xxxx] – it is confirmed by a sound signal modulated upward. The first four digits of
the password [1507] are a fixed value, and the following ones [xxxx] are a four-digit installer password (0000 – factory
setting). The activity time of the programming mode of the settings is limited to 10 sec., counting from the last change,
the exit from the programming mode takes place by means of push-button [#].
According to the factory-settings, the installer password is set to “0000” and after completion of the
installation, it must be changed to a different one (P7 programme).
After entering the lock programming function, specify the programme number, which corresponds to the given settings.
After entering the programme number, the lock will count the appropriate (depending on the programme number)
