ACO FUNKI Egebjerg MASTER Chain, Manual

Page: 15 / 24

Page 15 09-11-2018 · ACO FUNKI · Tlf. 97119600 · www.acofunki.com
FEEDING SYSTEM MASTER CHAIN
®
Mount a wire roll on the opposite wall.
Tighten the piano thread until the spring is approx. 50% stretched out. Cut off the piano thread approx. 25 cm
before the wire roll.
Make a loop at the end of the thread. The piano thread is now ready for use.
Pull a 3 mm wire from the opening device through the wire roll and approx. 15-20 cm after the wire roll.
Make a loop at either end of the wire. Attach it to the piano thread using a wire strainer and the opening device
using a shackle.
Now connect the system: end wall with bracket – spring – piano thread – wire strainer – wire – wire roll – opening
device.
Where several lines are used, join the wire along the wall in front of the opening device. Take care to apply
uniform tension on each line.
Adjusting the opening device
Set the opening device in position closed!
The spring on each line should be pre-stretched to approx. 50%.
Adjust the lines using the wire strainers.
Then, tighten the screw on the individual opening arm, putting them in position closed on each feed box.
Test by putting the opening device in position open.
Now, all feed dispensers must be open and the spring must keep the piano thread tight.
The spring should be tense in position open!
Tip!
The piano thread and wire will stretch slightly after a while. Check that all feed dispensers are opened completely
when the opening system is in position open.
2 mm pianothread
Wirestrainer
3 mm wire
Min. 25 cm.
Min. 25 cm.
Closed
Open
Open
Closed